24-400xg
Battery Charger-Analyzer for small battery systems
(up to 10A-Hr)
(replaces the earlier 24-400T)
- The 24-400XG is an instrument designed to charge, trickle charge and analyze (discharge) Nickel-Cadmium, Sealed Lead-Acid and other types of rechargeable batteries.
The 24-400XG is an instrument designed to charge, trickle charge and analyze (discharge) Nickel-Cadmium, Sealed Lead-Acid and other types of rechargeable batteries.
With its multiple modes of operation of Constant Current Charge (dual and single rate), Constant Current & Float Charge, Constant Current & Peak Stop Charge, Automatic Discharge (analysis), Resistance Discharge (analysis) and Full Discharge (deep cycle), the 24-400XG can satisfy the requirements of most small (0 to 10 A-hr) rechargeable battery systems.
The instrument features safety interlocks to protect the operator, the charger and the battery in the event of reversed polarity connection, short circuit, open circuit (no load) and Overvoltage conditions.Two large LED digital meters permit the simultaneous monitoring of voltage and current, while eight indicator lights inform of the status of the operation.
Storage (nonvolatile) of battery test profiles
Battery temperature monitoring
Microprocessor based timer with HH:MM and MM:SS timing selection
Interfacing to the BTAS16 Computerized Battery Test System for monitoring, programming and controlSuggested Accessory: we recommend the CAL-100 to simplify the task of testing and calibration the Charger-Analyzer.
CURRENT
Charge: constant current, adjustable: 0 to 1.999A, in steps of 1mA (0.002A).
Discharge: constant current, adjustable: 0 to 10.00A, in steps of 10mA (0.01A).
VOLTAGE
Charge: 0 to 40V.
Discharge: 3 to 24V at full current, and up to 44V at reduced current (240W max power
dissipation).
Constant Current Charge
Single Rate
Single Rate with stop at peak voltage
Dual Rate
Dual Rate with transfer at peak voltage
(all with optional Overvoltage)
Constant Voltage Charge.
Constant Current followed by Constant Voltage
Discharge
Constant Current Capacity Test
Constant Resistance Load Capacity Test
Full Discharge
VOLTAGE CONTROL
Adjustable: Usable from 3.00 to 44.0V, with an
accuracy of 2% ±.1V
Voltage: 3-1/2 digit, LED digital panel meter, 0 to 19.99 and 199.9V scales.
Current: 3-1/2 digit, LED digital panel meter, 0 to 1.999A scale for charge and 0 to 19.99A scale for discharge.
CONTROLS
24 button keypad to select the Test Mode,
program the Test Parameters and view status and results.
DISPLAY
24 button keypad to select the Test Mode,
program the Test Parameters and view status and results.
STATUS INDICATORS
RESET and CYCLE END.
MAIN and TOPPING CHARGE.
DISCHARGE.
PEAK VOLTAGE END.
CAPACITY FAILURE END.
WARNING and FAULT
Microprocessor controlled with HH:MM, MM:SS elapsed time selection.
PROTECTION
Battery Overtemp
Battery Temperature monitoring by way of an external cable or
Temp-Plate
Overheat
Monitoring of internal Heat Dissipators
Power Failure
Internal rechargeable battery.
Current
Microprocessor monitored for over and under current faults
Fusing for Line, Charge
output and Discharge output.
115/230VAC ±10%, 50-60Hz.
AMBIENT
+5oC to +35oC (contact
factory for extended temperature operation).
9891601011
APPROVALS
TBA
Note: Specifications subject to change without notice
