The SuperMini is an instrument designed to charge, trickle charge and analyze (discharge) Nickel-Cadmium, Sealed Lead-Acid and other types of rechargeable batteries.

With its multiple modes of operation of Constant Current Charge (dual and single rate), Constant Current & Float Charge, Constant Current & Peak Stop Charge, Automatic Discharge (analysis), Resistance Discharge (analysis) and Full Discharge (deep cycle), the SuperMasterCharger can satisfy the requirements of most large (10 A-hr to 100A-hr) rechargeable battery systems.

The instrument features safety interlocks to protect the operator, the charger and the battery in the event of reversed polarity connection, short circuit, open circuit (no load) and Overvoltage conditions.

Two large LED digital meters permit the simultaneous monitoring of voltage and current, while eight indicator lights inform of the status of the operation.

Storage (nonvolatile) of battery test profiles

Battery temperature monitoring

Microprocessor based timer with HH:MM and MM:SS timing selection

Interfacing to the BTAS16 Computerized Battery Test System for monitoring, programming and control

Suggested Accessory: we recommend the VCM-100 to simplify the task of testing and calibration the Charger-Analyzer.

SPECIFICATIONS 

CURRENT
Charge: constant current, programmable: 0 to 20.0A, in steps of 0.1A.
Discharge: constant current, programmable: 0 to 40.0A, in steps of 0.1A.

VOLTAGE
Charge: 0 to 37V
Discharge: 3 to 24V (other voltages, dissipation limited).

MODES
Constant Current Charge
    Single Rate
    Single Rate with stop at peak voltage
    Dual Rate
    Dual Rate with transfer at peak voltage
    (all with optional Overvoltage)
Constant Voltage Charge.
    Constant Current followed by Constant Voltage
Discharge
    Constant Current Capacity Test
    Constant Resistance Load Capacity Test
    Full Discharge

VOLTAGE CONTROL
Adjustable: Usable from 3.00 to 80.0V, with an accuracy of 2% ± 0.1V

METERS
Voltage: 3-1/2 digit, LED digital panel meter, 0 to 19.99V and 199.9V scales.    
Current: 3-1/2 digit, LED digital panel meter, 0 to 199.9A scale for charge and discharge.  

CONTROLS
24 button keypad to select the Test Mode, program the Test Parameters and view status and results.

DISPLAY
LCD readout with 4 lines x 20 characters.

STATUS INDICATORS
RESET and CYCLE END.
MAIN and TOPPING CHARGE.
DISCHARGE.
PEAK VOLTAGE END.
CAPACITY FAILURE END.
WARNING and FAULT

TIMER
Microprocessor controlled with HH:MM and MM:SS elapsed time selection.

PROTECTION
Battery Overtemp
    Battery Temperature monitoring by way of an external cable or Temp-Plate
Overheat
    Monitoring of internal Heat Dissipators
Power Failure
    Internal rechargeable battery.
Current
    Microprocessor monitored for over and under current faults
    Fusing for Line, Charge output and Discharge output.

LINE VOLTAGE
115VAC / 208,230,245VAC ±10%, 50-60Hz.

AMBIENT
+5^oC to +35^oC (contact factory for extended temperature operation).

PART NUMBER
9899602001

APPROVALS
TBA

ACCESSORIES INCLUDED
BATTERY CABLE: Cable to connect the Charger-Analyzer to one or two batteries
TEMP-PLATE: Plate to measure the temperature of the battery(ies)
SINGLE CELL ADAPTOR: Short cable with clips to charge a single cell or a group of cells
MISC: Fuses and Current Limiter

BROCHURE

MANUAL

PARTS

Note: Specifications subject to change without notice